Characteristics of microfiber hotel towels
1. Hotel towels have high water absorption
The ultra-fine fiber adopts orange petal technology to divide the filament into eight petals, which increases the fiber surface area and the pores in the fabric. With the help of capillary wicking effect, the water absorption effect can be effectively enhanced. Rapid water absorption and rapid drying are the remarkable characteristics of hotel towels.
2. Hotel towels have strong detergency
The fiber fineness is 1/10 of real silk and 1/200 of hair silk. Its special cross section can more effectively capture dust particles as small as a few microns. Therefore, the decontamination and oil removal effect of hotel towels is very significant.
3. Hotel towels are not easy to depilate
The hotel towel is made of high-strength synthetic fiber filament, which is not easy to break. At the same time, it adopts fine knitting method, which is not easy to pull out, do not fall off, and the fiber is not easy to fall off from the towel surface. It is especially suitable for wiping bright paint surfaces, electroplated surfaces, glass, instruments and LCD screens. It can achieve a very ideal film pasting effect by cleaning the glass in the process of car film pasting.
4. Long service life of hotel towels
Due to its high strength and toughness, the service life of superfine fiber is more than four times that of ordinary towels. It will not deform after repeated washing. At the same time, polymer fibers will not produce protein hydrolysis like cotton fibers. Even if they are not exposed to the sun after use, they will not mildew and rot, and have an ultra long service life.
5. Hotel towels are easy to clean
When using ordinary towels, especially natural fiber towels, the dust, grease, dirt, etc. on the surface of the object to be wiped are directly absorbed into the fiber. After use, these dirt remain in the fiber, which is not easy to remove. After a long time of use, they will even harden and lose elasticity, affecting the use. The microfiber towel adsorbs the dirt between the fibers (not inside the fibers). In addition, the fiber has high fineness and density, so it has strong adsorption capacity. After use, it can be cleaned with water or a little detergent.
6. Hotel towels are not easy to fade
TF-215 and other dyes for microfiber materials are used in the dyeing process. Their dyeing retardation, migration, high-temperature dispersion and achromaticity indexes all meet the strict standards for export to the international market, especially their advantages of non fading, so that they will not bring the trouble of decolorization and pollution when cleaning the surface of articles.
Washing matters of cotton hotel towels
1. Water quality:
It is recommended that the washing water be softened. Moderate washing procedure is adopted for washing intensity.
2. The first water passing is very important:
Many new towels and bathrobes have something to do with the improper operation of the first pass. The pilling of towels and bathrobes is also related to the water passing procedure.
3. Suggestions for initial washing with water:
The washing temperature should not exceed 60 ℃. The main washing time is slightly shorter than the normal washing time.Because the new bathrobe has almost no pollution, it is recommended not to put softener into the towel or bathrobe to avoid non absorption of water, or chemical reaction with the softener of the original towel or bathrobe, causing the towel or bathrobe to turn yellow. It is recommended to wash with clean water for the first time.
4. Washing pretreatment:
Before washing with chemicals, the washing products should be pre washed, and the impurities in the washing products and the dirt with weak adhesion should be cleaned by washing and washing with cold water.
5. Main washing:
The water temperature should not exceed 75 ℃. At the same time, the installed capacity must be 70% - 80% of the loading capacity; Especially when the installed capacity is obviously insufficient, it will improve the washing strength of the linen, thus affecting the service life of the linen.
6. Bleaching:
Oxygen bleaching should be used instead of chlorine bleaching. In particular, new towels and bathrobes have good water absorption and also good permeability to bleach. If this link is not well controlled, the damage to the new towel and bathrobe will be greater than the old towel. This is also one of the reasons for the damage of new towels and bathrobes in some hotels. When putting bleach into new products, the bleach must be adjusted evenly. Control the washing temperature and pH value.
7. Overflow:
To thoroughly filter out the detergent residue on towels and bathrobes. It is recommended that the number of water passes should not be less than: 2. When washing, the water should be sufficient. If the washing water is insufficient, the impurities, dirt and washing agents stripped from the washing water will adhere to the product surface again, which will not only affect the washing effect, but also cause damage to the interior of the fiber. When washing white products, try to wash the chlorine. The existence of chlorine will cause excessive oxidation of fibers, resulting in the yellowing of white towels.
8. Drying:
The drying standard is to dry the towel to 80%. When towels and bathrobes are taken out of the oven, obvious moisture should be seen, which can reduce the dry friction of towels. This link is very important: it has a significant impact on the softness of towels and bathrobes, whether they turn yellow, whether they become brittle, and their service life. After drying, cool air should be applied to restore the good elasticity of towels and bathrobes. Generally, the drying temperature of cotton fiber is 80 ℃.
9. Dehydration:
When drying at high speed, pay attention to observe the perspective lens. If there is winding, stop the machine in time, and then dry it after re conditioning. If you use a dehydrator to dry, add a clean cover cloth, which will also effectively reduce damage.
10. End of washing:
When unloading items, be careful not to pull them with great force, which is easy to be damaged.
11. Regular inspection:
Regularly check whether there are burrs on the inner wall of the washing equipment. If there are burrs, they should be removed in time to avoid damage to the towel.
Hotel collection towel set, hotel linen manufacturer, supplier in China.
Weclome to contact us to get detailed offer according to your exact request.